top of page

One and a third HP 1,000 Watt Computer Controlled Servo Motor.
Includes stand alone Driver with built in rotary speed control switch.
This Universal Mount Version comes with internal Speed Control.

 

2024 Version Controller:
Now comes with 2024 year model reverse on the fly controller.
I will post images soon

Universal Mount:
See images for measurements.

 

Optional drive pulleys:
Comes standard with AK25 that is a 2.0 OD 1/2 inch wide pulley.
Contact us before you order if you want something else.

US version, Metric version, Toothed version, Multi Rib version and Custom made are available.

 

See images for measurements.
Note: the maximum distance between control unit and motor is 28 inches.

Runs on typical 110 to 120 volt AC household power supply's

Ajustable Universal Motor Mount
See images for measurments.

 

Motor programming + spindle speeds and Reverse:

  • The motor speed can be programmed to operate in any range chosen by the user.
    Between 300 and 3,500 RPM's.
    Note: Settings are limited to 100 RPM intervals.That means it can be set to 500 RPM but it cannot be set to 550 RPM as the next step is 600 RPM
  • The full range of speed (RPM's) can also be controlled with just the speed control knob.
  • Speed control programming only requires a few easy steps.
  • Reverse is simple, just hold the yellow button for a few seconds.
  • Programming includes the ability to set bottom and top RPM range separately. In other words you can program
    the system to run the spindle at any speed or range of speeds you choose (see below).
    Slowest speed achievable: Motor 100 RPM. (Below 300 is not recommended).
    Highest speed: 3,500 RPM.
  • Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
  • Braking strength is also programmable and will be set as low as possible. Personally I wish I could set it lower.
  • Self diagnostics with fault code chart and programming instructions.
  • Safe turn on system where the speed control knob must be in the full counter clockwise (stop) position when turnedon. When turned on the self diagnostic system checks for faults and will not allow the motor to run until the speed control knob is turned all the way to stop first.
  • Use at your own risk. Our liability is limited to the purchase price of this item.

    1,000 Watt servo motor internal 1.34HP 12 NM torque 300~3,500 RPM

    $288.00Price
    Excluding Sales Tax
    • Motor Specifications:

      • Watt: 1,000 (1.3410220888 HP)
      • Voltage: 110 ~ 130 Volts AC single phase
      • HZ: 60
      • Torque: 12 N.M.
      • RPM: 100 to 3,500 RPM in 100 RPM increments.
        Note: Manufacturer recommended 500 to 3,000 RPMs My personal testing results: New item not yet tested on my machines.
        .
    bottom of page